
Installing the software
1. Use the file browser on the PC to navigate to the executable software file and
double-click it to open it.
2. Follow the instructions on the Installation Wizard screens to install the software to the
computer.
Running DataViewer
1. From the desktop, select Start > All Programs > Extron Electronics >
IPL Tools > DataViewer > Dataviewer. If a shortcut to DataViewer was placed on
the desktop, the software can be opened by double-clicking on the icon.
2. The DataViewer Communication Setup window opens (see figure 94).
NOTE: If the Communication Setup window does not appear, select File >
Connect from the menu bar.
Sending commands using a TCP/IP connection
1. Configure the network settings of a control PC so that it can be connected to the
same network as the SME100. Use an RJ-45 cable to connect the control PC to the
network.
2. Open DataViewer (see "Running DataViewer" above).
3. On the Communication Setup window (see figure 94):
Figure 94. TCP/IP Communication Setup Window
a. Select the TCP/IP tab.
b. Enter the IP address of the SME100 into the Hostname / IP Address field.
c. In the Telnet Port field, enter the port number for the connection.
NOTE: The default port to send SIS commands to the SME100 is port 23.
d. Click OK. The Communication Setup window closes.
SME 100 • Remote Communication and Control 119
Komentáře k této Příručce