Extron-electronics SME 100 User Guide Uživatelský manuál stáhnout pdf (Strana 113)

Creating a Custom EDID

Use the following procedure to create a custom EDID using the Advanced Settings page on

the SME100 (see figure 82).

Figure 82. Advanced Settings Page — Creating a Custom EDID

1. Connect a video output device to the 15-pin HD buffered loop connector (buffered

input2) or the DVI buffered loop connector (buffered input 3) located on the rear panel

of the SME100 (see the "Rear Panel Features" section on page 12).

2. Use the Select Input radio buttons to select the desired input (buffered input 2 or

buffered input 3) to capture EDID from.

3. From the Resolution drop-down menu, select a custom EDID number to store the

new display EDID.

NOTES:

• Custom 1, 2, and 3 capture EDID from the 15-pin HD buffered loop connector.

Custom 4, 5, and 6 capture EDID from the DVI buffered loop connector.

• The new EDID will overwrite existing custom EDID information.

• If a custom EDID is not captured, the resolution and refresh rate defaults to

1024x768 @ 60 Hz.

4. Click the Save Current EDID button to store the EDID to the custom location.

SME100 • Web-based Configuration Page 107

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 184 185

Žádné komentáře

Extron-electronics SME 100 User Guide Uživatelský manuál Strana 113