Extron-electronics Cable Retraction System User Guide Uživatelský manuál stáhnout pdf (Strana 22)

Cable Retraction System • Installation 16

3. Ensure the bracket is flush with the surface and trace a line around the bracket

perimeter.

Trace Around

Bracket Perimeter

Figure 16. Mark Bracket Location

4. Lower the assembly and remove the horizontal bracket from the retractors.

5. Position the bracket inside the lines drawn in step 3 and fasten with the supplied

screws.

ATTENTION: Ensure the supplied screws do not pierce through the top of the

table. If necessary, use appropriate screws based on the table material and

thickness.

Figure 17. Position Bracket and Mount

6. Raise the retractor system up into the installed bracket.

7. Run the bolt through the bracket and end caps.

8. Secure the bolt with the nut supplied in step 1.

ATTENTION: Do not overtighten the horizontal mounting nut. It only needs to

be snug. Overtightening could deform the end caps and cause misalignment

of the system resulting in poor cable extension and retraction.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Žádné komentáře

Extron-electronics Cable Retraction System User Guide Uživatelský manuál Strana 22