Extron-electronics Cable Retraction System User Guide Uživatelský manuál stáhnout pdf (Strana 13)

Cable Retraction System • Before Getting Started 7

TLP 350CV, TLP 710CV, TLE 350, TLE 710 Enclosure Clearances

The following diagrams show the clearance dimensions required for mounting a retractor

system in a TouchLink (TLP 350CV and TLP 710CV only) or the TLE series enclosures.

Horizontal Mounting Clearance

TLP 350CV/710CV TLE 350/710

XL Models

10.0"

(25.4 cm)

15.7"

(39.9 cm)

16.7"

(42.5 cm)

3.0"

(7.6 cm)

10.0"

(25.4 cm)

21.7"

(55.0 cm)

23.0"

(58.5 cm)

3.0"

(7.6 cm)

See

Ta ble A

1.9" (4.8 cm)

24.3"

(61.7 cm)

1.9" (4.8 cm)

30.3"

(77.0 cm)

Vertical Mounting Clearance

TLP 350CV/710CV TLE 350/710

XL Models

See

Table B

Figure 6. Vertical and Horizontal Clearance Requirements, TLP 350CV, TLP

710CV, TLE 350, and TLE 710

Retractor installation into the TLP and TLE enclosures is identical to the standard Cable

Cubby enclosures. The enclosures are one inch longer than the CC300/600/800

enclosures, but otherwise the dimensions are the same.

NOTE: Angular mounting requires an additional inch of floor clearance compared to

the Cable Cubby enclosures.

Enclosure Model Dimension

TLP/TLE 7.4 inches (18.8 cm)

Table A. Vertical Dimension from Table Top To Pigtail

(Horizonal Mounting)

Enclosure Model Dimension

TLP/TLE 10.5 inches (29.2 cm)

Table B. Vertical Dimension from Table Top To Pigtail

(Vertical Mounting)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Komentáře k této Příručce

Žádné komentáře

Extron-electronics Cable Retraction System User Guide Uživatelský manuál Strana 13

Komentáře k této Příručce

Související produkty a manuály pro Hardware Extron-electronics Cable Retraction System User Guide