Extron-electronics Cable Retraction System User Guide Uživatelský manuál Strana 16

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 36
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 15
Cable Retraction System • Before Getting Started 10
Prepare the Retractors
Each retractor is delivered ready to mount vertically. No further modifications are required.
See CC300, CC600, CC800, TLE, TLP Installation on page 14 for vertical installation
details.
Horizontal or Angular Mounting:
To mount the retractors horizontally or at an angle, remove the two enclosure screws
from the retractor (see figure 9).
For horizontal mounting proceed to the “Installation” section beginning on page 11.
For angular mounting, see below.
Remove two enclosure screws
(front and back) from this position
for horizontal or angular mounting.
Install two enclosure screws
(front and back) in angular
mounting location.
1
2
Cable Stop Assembly
Enclosure
Move cable stop assembly
upward until the angular
mounting hole is visible.
Figure 9. Remove Enclosure Screws (Horizontal or Angular Mounting Only)
Angular Mounting:
1. To prepare an XL retractor for angular mounting move the cable stop assembly upward
as shown until the mounting hole is visible.
Remove two enclosure screws
(front and back) from this position
for horizontal or angular mounting.
Install two enclosure screws
(front and back) in angular
mounting location.
1
2
Cable Stop Assembly
Enclosure
Move cable stop assembly
upward until the angular
mounting hole is visible.
Figure 10. Install Angular Mounting Enclosure Screws
2. Reinstall the two screws removed in the preparation above.
NOTE: For Cable Cubby 200 installations, mount the retractor onto the CC 200
mounting bracket before installing in the enclosure (see CC200 Bracket and
Retractor Mounting on page13).
Zobrazit stránku 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Komentáře k této Příručce

Žádné komentáře