Extron-electronics DVCM 50 User’s Manual Uživatelský manuál stáhnout pdf (Strana 14)

Installation, cont’d

DVCM 50 • Installation

2-6

PRELIMINARY

3. Attach a 3.5 mm, 5-pole captive screw connector to each end of the cable.

Only three wires are required:

• A (DVCM) to A (IR Link)

• B (DVCM) to B (IR Link)

• C (DVCM) to D (IR Link)

4. Connect the wires as shown in the illustration below. Connectors are included

with the IR Link, but the cable must be purchased separately.

5. Plug one 5-pole connector into one of the IR Link’s communications

connectors.

6. Plug the other 5-pole connector into the rear panel control port of the

DVCM 50.

IR Link (Rear Panel)

DVCM 50 (Rear Panel)

8421

234

IR OUT

GND

IR IN

GND

+ 12V

GND

+12V

GND

+12 V

IR IN

Wiring the IR Link for IR 452 remote control

Connect a maximum of one IR Link or IRL 20 to the DVCM 50.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 69 70

Žádné komentáře

Extron-electronics DVCM 50 User’s Manual Uživatelský manuál Strana 14