Extron-electronics Fiber Optic Termination Kit Uživatelský manuál stáhnout pdf

2. Slide the appropriate size boot onto the

cable with the threads toward the end to be

terminated.

To Terminate a Fiber Cable

1. Lay the required tools and components out on a

clean work surface. Begin by placing the cable

clamp about 10 inches from the end of the cable.

This will prevent the inner cable from being pulled

out as the cable is stripped.

3. Set a connector with wedge clip into the

assembly tool.

NOTE: The wedge clip is engaged at shipment.

If it has become dislodged, squeeze the

top and bottom ensuring the wedge clip is

inserted into the connector body. A click

will be heard.

1 2

Fiber Optic Termination Kit • User Guide

This guide provides instructions for the Extron Fiber Optic Termination Kit. The kit contains

the necessary tools required for an experienced technician to properly terminate LC single

or multimode 2 mm ﬁber optic cable.

NOTE: Visit the ﬁber optic termination kit page at www.extron.com for an interactive

video describing how to terminate an LC connector using this kit.

The following items are included in this kit:

Fiber Stripper

Visual Fault Locator

(VFL)

Installation

Instructions

Fiber Preparation

Fluid

Marker Pen

Lint-free Cloth Wipes

Cleaver w/

Case

Kevlar® Scissors

Cleave/Strip

Gauge

Cable Clamp

Cable Grip

Assembly Tool

Extron

Fiber Optic Strip/Cleave Length

Extron Electronics

Anaheim, CA

www.extron.com 68-2049-01 A

Mark Cable

Boot

2mm and 3mm Fiber Cable

Strip 40 mm

Strip 70 mm

11.5 mm

(LC)

Buffer

Kevlar Strans

Glass Fiber

Core

Jacket

HOLD

1 sec

VFL 101

WARNING: To prevent eye damage, always wear eye protection when handling

optical ﬁbers. Do not touch the glass ﬁber. Dispose of cut or cleaved ends

properly.

1 2 3 4

Shrnutí obsahu

Strany 1 - To Terminate a Fiber Cable

2. Slide the appropriate size boot onto the cable with the threads toward the end to be terminated.To Terminate a Fiber Cable1. Lay the required too

Strany 2 - 2mm and 3mm Fiber Cable

Fiber Optics Termination Kit • User Guide (Continued)10.5 mm Position5. Again using the included strip gauge, place a mark on the buffer 35 mm from t

Strany 3

11. Remove the cable from the assembly tool cable grip long enough to slide the boot past the grip. Straighten the cable and return it to the cable g

Strany 4 - 68‑2048‑01

Fiber Optics Termination Kit • User Guide (Continued)Extron USA - West Headquarters+800.633.9876Inside USA and Canada Only+1.714.491.1500+1.714.491.1

Komentáře k této Příručce

Žádné komentáře

Extron-electronics Fiber Optic Termination Kit Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware Extron-electronics Fiber Optic Termination Kit. Extron Electronics Fiber Optic Termination Kit User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Hardware Extron-electronics Fiber Optic Termination Kit