Extron electronics SW12 VGA Ars Provozní pokyny stáhnout pdf (Strana 14)

2-5

SW8/12 VGA Ars • Installation and Operation

Mounting through a desktop

Through desktop mounting requires the included MBD1491U,through-deskand

rack mounting kit (part #70-077-03).

MountanSW8/12VGAArsunitthroughadesktopasfollows:

1. Ifpresent,removethefourrubberfeetfromthebottomoftheunit.

2. Cutanappropriatelysizedholeinthedesktop.

3. Looselyinstallthemountingbracketsontheunit’ssideswithfourmachine

screws provided in the kit.

. Holdtheunit(withbracketsattached)againsttheunderside of the desk.

Markeachbracket'sholelocationontheundersideofthedesk.

5. Drill1/4"(6.4mm)deep,3/32"(2mm)diameterpilotholesfromthe

underside of the desk at the marked hole locations.

. Holdtheunitinplacesothemountingbracketholeslineupwiththepilot

holes in the desktop.

. Installthefoursuppliedwoodscrewsthroughthemountingbracketsandinto

the pilot holes.

. Tighten the wood screws to secure the mounting brackets to the underside of

the desktop.

. Slide the switcher up or down inside the mounting brackets to achieve the

desired height above the desktop.

. Tighten the machine screws to secure the switcher in position.

Figure 2-3 — Mounting the switcher through a desktop

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 40 41

Žádné komentáře

Extron electronics SW12 VGA Ars Provozní pokyny Strana 14