Extron-electronics UTS 100 Series Setup Guide Uživatelský manuál stáhnout pdf

UTS 100 (70-1028-01)

(8) #4-40 x 3/16 inch product mounting screw

(4) #8 x 1/2 inch shelf mounting screw

UTS 150 (70-1028-02)

(8) #4-40 x 3/16 inch product mounting screw

(2) #8-32 Thumbnut

Step 1 — Mount Devices on the Shelf

ATTENTION: Some products have hexagonal holes

in their base, which anchor stand-offs for internal circuit

boards (see the gure to the right). Using these holes will

damage the product and will not provide secure mounting.

Before securing a device to the shelf, decide where the device

will be placed. Ensure that adequate space remains for running

cables.

1. Place the device on the shelf so that the rack mounting

holes are aligned with two diagonally opposite product

mounting holes in the shelf (see gure at right).

Remove any rubber feet attached to the device.

2. Secure the device to the shelf, using two

of the provided #4-40 x 3/16 inch

screws.

3. Use the rectangular (wire tie)

openings for tie wraps if

necessary.

UTS 100 Series • Setup Guide

The Extron UTS100 and UTS 150 under-table shelf system accommodates half-rack,

quarter-rack, and eighth-rack products in a half-rack width installation. The shelves can

accommodate a single device or combinations of smaller devices.

Included Parts

Step 2 — Install the UTS 100 (Primary Shelf) Under the Table

The UTS 100 may be mounted under furniture in

one of two ways: using the keyhole slots for

a removable installation or the clearance

holes for a fixed installation.

1. Hold the UTS 100 under

the desk or table and mark

the locations of four corner

mounting holes.

Clearance

hole

Keyhole

slot

#4-40 Thread for

Rack Mounting

Hexagonal

Stand-off (for

mounting circuit

board)

Use 2 mounting holes on diagonally

opposite corners of device.

(2) #4-40 x 3/16"

screws

UTS 100

Wire tie

openings

Product

mounting

holes

1 2

Shrnutí obsahu

Strany 1 - UTS 100 Series • Setup Guide

UTS 100 (70-1028-01)(8) #4-40 x 3/16 inch product mounting screw(4) #8 x 1/2 inch shelf mounting screwUTS 150 (70-1028-02)(8) #4-40 x 3/16 inch produc

Strany 2 - 68-2357-50

Step 3 — Install the UTS 150 (Secondary Shelf)1. Insert the hooks of the UTS 150 into the front posts and rear studs of the top adjacent shelf, then

Komentáře k této Příručce

Žádné komentáře

Extron-electronics UTS 100 Series Setup Guide Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware Extron-electronics UTS 100 Series Setup Guide. Extron Electronics UTS 100 Series Setup Guide User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Hardware Extron-electronics UTS 100 Series Setup Guide