Extron-electronics PowerCage FOX Tx_Rx DVI Plus User Guide Uživatelský manuál stáhnout pdf (Strana 24)

Unit-initiated Messages

When a local event, such as an equipment power-up, occurs, the unit responds by sending a

message to the host. The unit-initiated messages are listed below:

Tx VGA, Vx.xx, 70-699-xx

]]

- or -

Rx VGA, Vx.xx, 70-699-xx

]]

- or -

DVI, Vx.xx, 70-700-xx

]]

- or -

DVI, Vx.xx, 70-700-xx

]]

- or -

DVI Plus, Vx.xx, 70-873-xx

]]

- or -

DVI Plus, Vx.xx, 70-873-xx

]]

The connected unit issues the appropriate copyright message (above) when it ﬁrst powers

on. Vx.xx is the ﬁrmware version number; 70-xxx-xx is the part number of the connected

unit.

Reconfig

]

The unit sends the Reconﬁg message whenever the video input signal to the transmitter is

changed.

1Lnk

X1(

•2Lnk

X1(

•RGB

X1(

•Aud

X1(

]

The unit sends the status message whenever a change in the ﬁber link and video and audio

connection occurs.

Dip

X$X$

]

The unit sends the DIP switch position message whenever a change in the DIP switch

settings on the receiver occurs.

NOTES: • The Dip

X$X$

]

message occurs only when the connected receiver is a FOXBOX

unit.

• Only DIP switch 1 (the ﬁrst

) has any effect on the system operation. When

the switch is on (up), the receiver is in daisy chain mode.

PowerCage FOX DVI and PowerCage FOX VGA • Remote Control 19

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 47 48

Komentáře k této Příručce

Žádné komentáře

Extron-electronics PowerCage FOX Tx_Rx DVI Plus User Guide Uživatelský manuál Strana 24

Komentáře k této Příručce

Související produkty a manuály pro Hardware Extron-electronics PowerCage FOX Tx_Rx DVI Plus User Guide