Extron-electronics MTP U T A D User Guide Uživatelský manuál stáhnout pdf (Strana 16)

MTP U T A D • Installation and Operation 10

Rear Panel Features

OUTPUT

12 V

.5A

MAX

Figure 6. Transmitter Rear Panel Features

k Output connector — Connect a TP cable from this RJ-45 female connector to the

compatible receiver (see “TP Cable Termination” to wire the RJ-45 connectors).

NOTE: See the table on page 3 for recommended transmission ranges.

l Contact closure controls — To select a video input to output, momentarily tie the

assigned pin for that format to ground.

Pin Format Pin Format Pin Ground

1 Composite 3 YUV 5 Ground

2 S-video 4 PC

NOTE: The front panel Contact DIP switch (

) must be on (up) for contact closure

to be available.

m DC power connector — Plug the external 12 VDC, 1 A power supply into this 2-pole

captive screw connector (see "Power Supply Wiring" to wire the connectors).

NOTE: The remote power capabilities available with certain MTP models are not

supported by this unit; the transmitter and receiver both must be powered.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Žádné komentáře

Extron-electronics MTP U T A D User Guide Uživatelský manuál Strana 16