Extron-electronics MLA VC10 Plus Setup Guide Uživatelský manuál stáhnout pdf (Strana 1)

MLA VC10 Plus • Setup Guide

The Extron MLA VC10 Plus Volume Control Module converts RS-232 commands from a

control system into voltage or impedance changes to control audio amplifiers with volume

and mute control ports. The MLA VC10 Plus mutes or makes level changes on an Extron

MPA Series or half rack XTRA

™

Series amplifier from a TouchLink

™

Touchpanel system, an

RS-232-capable MediaLink

Control Processor, or a third-party control system. The control

module also supports third-party amplifiers that use either variable voltage or 10 kilohm

potentiometer control.

This setup guide provides instructions for quick installation and configuration of the

MLA VC10 Plus with Extron products or some common third-party amplifiers. Installation

and service must be performed by experienced installers only. For complete features,

functions, and configuration instructions, read the user guides that come with your control

processor and amplifier and see the MLA VC10 Plus User Guide, which is available at

www.extron.com.

CONFIG

RELAY

MUTE

MLA VC10 Plus

RS-232

RELAY

V-DC

Tx Rx GG GVC

NO NCC

POWER

0.3A MAX

12V

CONTROL

OUTPUT

REMOTE

fg jih

Front Panel

Power and Activity LED

Mute LED

Relay LED

USB Configuration Port

Reset Button

Rear Panel

Power input

RS-232 Control

Variable Voltage Control

Resistance (Potentiometer)

Control

Relay Control

1 2 3 4 5 6

Shrnutí obsahu

Strany 1 - Rear Panel

1MLA VC10 Plus • Setup GuideThe Extron MLA VC10 Plus Volume Control Module converts RS-232 commands from a control system into voltage or impedance ch

Strany 2 - Installation

MLA VC10 Plus • Setup Guide (Continued)2Application DiagramRS-232RELAYV-DCRTx Rx G G GV CNO NCCPOWER0.3A MAX12VCONTROLOUTPUTREMOTECONFIGDISPLAYVOLUME1

Strany 3 - VOL/MUTE

3Remote Volume Control Connections to AmpliersThe following examples show how to wire the resistance control terminals of the MLA VC10 Plus to an Ext

Strany 4 - Extron MLA VC10 Plus

MLA VC10 Plus • Setup Guide (Continued)4Connecting the RS-232 ControllerConnect the RS-232 pins to the control processor. This example shows the conne

Strany 5 - C Common

5Power ConnectionUse the 2-pole, 3.5 mm captive screw power connector to connect a power supply (not provided). The MLA VC10 Plus can share a power su

Strany 6 - EV*7.50VLCM}

MLA VC10 Plus • Setup Guide (Continued)668-1828-50 Rev. D 06 12Using Variable Voltage to Control VolumeA few amplifiers cannot be controlled by the po

Komentáře k této Příručce

Žádné komentáře

Extron-electronics MLA VC10 Plus Setup Guide Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware Extron-electronics MLA VC10 Plus Setup Guide. Extron Electronics MLA VC10 Plus Setup Guide User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Extron-electronics MLA VC10 Plus Setup Guide Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware Extron-electronics MLA VC10 Plus Setup Guide. Extron Electronics MLA VC10 Plus Setup Guide User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Hardware Extron-electronics MLA VC10 Plus Setup Guide