Extron electronics Matrix 200 Uživatelská příručka stáhnout pdf (Strana 90)

Alarms and SNMP

This section describes the following:

• Overview – Alarms

• Overview – SNMP

• SNMP Trap Destinations

Overview – Alarms

The VN-Matrix system is configured to generate alarms for error conditions. A list of these

error conditions and their meanings are presented on the following pages.

Alarms can be monitored at a number of locations throughout the web GUI

• In the Alarms page

• In the list immediately below the Filter Settings box. This details the alarm

conditions that are currently active on the system.

• In the Alarm Logs page

• In the list immediately below the Filter Settings box. This provides a historical log

of when an alarm condition was raised and cleared.

• In the Device List page

• Where a traffic light system is used to represent the status of a device.

• In the top left hand corner of each page in the web GUI.

• Where the device status and system status is displayed.

In addition the red LED located on the front panel of the VN-Matrix device will illuminate

whenever a critical alarm is triggered.

Alarm conditions, once triggered, will remain active until the error that caused it has

cleared and then for an additional five seconds.

VN-Matrix 200 Series • Alarms and SNMP 85

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 122 123

Žádné komentáře

Extron electronics Matrix 200 Uživatelská příručka Strana 90