Extron-electronics IPI 200 Series User Guide Uživatelský manuál Strana 32

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 86
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 31
Initia Conguration, cont’d
IPI 100 and IPI 200 Series • Initial Conguration
4-4
Setting the IP address using embedded Web pages
EachIPI200Seriesintercomunitcontainsanon‑boardWebserverwithinteractive
pages that can be used to configure the device.
The intercom unit must be at its factory default IP address.
TosetanIPaddressviaembeddedWebpages:
1. Connect an Ethernet crossover cable between the device and a local PC.
2. OnthePC,locatetheTCP/IPPropertiesdialogbox.
OnWindowsXP,theTCP/IPPropertiesdialogboxisfoundat:
Start > My Network Places>right‑clicktoProperties > Local Area
Connection > right-click to Properties > Internet Protocol (TCP/IP) >
Properties.
3
. Record the current IP address, subnet mask, default gateway and DHCP
settings. You will need this information later to return the PC to its original
TCP/IPsettings.
IP Address:
. . .
SubnetMask:
. . .
4. Enter the following:
IPaddress:192.168.254.253
Subnetmask:255.255.0.0
Defaultgateway:<blank>
5. Click OK.
6. OpenaWebbrowseronthelocalPC.
7. Enter192.168.254.254inthebrowser’sAddresseldandpresstheEnterkey.
Theintercomunit’sembeddedWebpageisdisplayed.
8. Click the Configuration tab.
Zobrazit stránku 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 85 86

Komentáře k této Příručce

Žádné komentáře