Extron-electronics MP 101 Series User Guide Uživatelský manuál stáhnout pdf (Strana 28)

4-3

MP 101 Series • MP 101 D

Do not tin the stripped power supply leads before

installing the captive screw connector. Tinned wires are

not as secure in the captive screw connectors and could

pull out.

The two power cord wires must be kept separate while

the power supply is plugged in. Remove power before

continuing.

Audio output (line level)

Phantom power switch — Provides switchable 48 volt phantom

power for condenser microphones.

Line Output — A 3-pin, captive screw connector outputs to

audio mixers, amps switchers, or other non-microphone audio

equipment.

Tip

Sleeve

NO Ground Here

CAUTION

For unbalanced audio, connect the sleeve(s)

to the ground. DO NOT connect the sleeve(s)

to the negative (-) contact.

(5 mm) MAX

Captive Screw

Connector stripping

3/16"

Tip

Sleeve

Ring

Low Cut ﬁ lter switch — Provides low cut ﬁ ltering to remove

wind and “table rumble” noise.

Remote connection

Remote — An optional 3-pin, captive screw connector allows

a wall mounted audio controller or MediaLink product to

remotely control volume and mute levels for the MP 101

unit. See “Remote Control”, later in this chapter, for more

information.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 46 47

Žádné komentáře

Extron-electronics MP 101 Series User Guide Uživatelský manuál Strana 28