Extron-electronics FOX SW8 User Guide Uživatelský manuál stáhnout pdf (Strana 10)

FOX SW8 • Installation and Operation 4

Installation and

Operation

The topics covered in this section are:

• Rear Panel Connections

• Front Panel Configuration Port

• Controls, Indicators, and Operation

Rear Panel Connections

100-240V 0.3A

50/60 Hz

RS-232

Tx Rx

FOX SW8

OPTICAL INPUTS

LOOP IN LOOP IN LOOP IN LOOP IN LOOP IN LOOP IN LOOP IN OUTIN

12345678

1 3 4

3 3

2 2222

Figure 2. FOX SW8 Connectors

WARNING: Risk of serious physical injury: The FOX SW8 outputs continuous

invisible light, which may be harmful to the eyes; use with caution.

• Do not look into the rear panel ﬁber optic cable connectors or into the ﬁber optic

cables themselves.

• Plug the attached dust caps into the optical transceivers when the ﬁber cable is

unplugged.

NOTES:

• Singlemode and multimode devices are not interchangeable. Ensure that the

connected transmitting and receiving devices are compatible with the FOX SW8.

• Ensure that you use the proper ﬁber cable for your system. Typically, singlemode

ﬁber has a yellow jacket and multimode cable has an orange or aqua jacket.

• In this guide, the term “sending connector” refers to an LC connector on a device

that outputs a ﬁber optic signal. The term “receiving connector” refers to an LC

connector that receives an optical signal.

a AC power connector — Plug a standard IEC power cord into this connector to

connect the FOX SW8 to a 100 VAC to 240 VAC, 50-60 Hz power source.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

Žádné komentáře

Extron-electronics FOX SW8 User Guide Uživatelský manuál Strana 10