Extron-electronics FOX DA8 Plus User Guide Uživatelský manuál stáhnout pdf (Strana 10)

Installation and

Operation

The topics covered in this section are:

• Rear Panel Features

• Front Panel Features

• System Operation

Rear Panel Features

FOX DA8 Plus

100-240V 0.3A

OPTICAL OUTPUTS

ABCD

OUTIN

(1)1x8

(2)1x4

(4)1x2

50/60 Hz

RS-232

Tx Rx

OUTN/A

OUT N/A

* See first NOTE, below.

3 3 42*3 32*3 32*3 32

Figure 2. FOX DA8 Plus Connectors

WARNING: Risk of serious physical injury: This unit outputs continuous invisible

light, which may be harmful to the eyes; use with caution. For additional

safety, plug the attached dust caps into the optical transceivers when the

fiber optic cable is unplugged.

NOTES: • Input LC connectors (on the right) marked with an asterisk (*) in figure 2

(inputs 3, 5, and 7) are functional only when selected as an input using the

DA configuration switch (item d). The connector on the right for transceiver

blocks 2, 4, 6, and 8 can never be functional.

• Singlemode and multimode devices are not interchangeable. Ensure that

you connect transmitting and receiving devices that are compatible with the

FOX DA8 Plus.

• Ensure that you use the proper fiber cable for your system. Typically,

singlemode fiber has a yellow jacket and multimode cable has an orange or

aqua jacket.

• In this guide, the term “sending connector” refers to an LC connector on a

device that outputs a fiber optic signal. The term “receiving connector” refers

to an LC connector that receives an optical signal.

FOX DA8 Plus • Installation and Operation 4

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

Žádné komentáře

Extron-electronics FOX DA8 Plus User Guide Uživatelský manuál Strana 10