Extron-electronics DTP T USW 233 User Guide Uživatelský manuál stáhnout pdf (Strana 25)

DTP T USW 233 • Reference Information 20

3. Locate and lift off jumpers JMP1 and JMP2 (see figure 12).

JMP2

Figure 12. Jumper Locations

4. Reinstall the switcher cover, securing it in place with the screws removed in step 2.

5. Reinstall the switcher in the rack or other installation option (see Mounting the

Switcher on page 18).

6. If you are using shielded cable, disconnect the cable shield from the connector at

either end of the cable.

7. See the manual for the applicable receiver, DTP DVI 230 Rx or DTP HDMI 230 Rx,

available on the Extron website (www.extron.com), and remove the ground jumpers in

the receiver.

8. Obtain a second 12 V power supply (one supply is provided with the switching

transmitter and normally powers both units), and locally power both units (see Power

supply wiring on page 7).

1 2 ... 20 21 22 23 24 25 26

Žádné komentáře

Extron-electronics DTP T USW 233 User Guide Uživatelský manuál Strana 25