Extron-electronics MPS 602 Series Setup Guide Uživatelský manuál stáhnout pdf

IMPORTANT:

Go to www.extron.com for the complete

user guide, installation instructions, and

specifications before connecting the

product to the power source.

MPS602 Series • Setup Guide

This guide provides basic instructions for an experienced technician to install, set up, and operate the Extron Media Presentation

Switcher, MPS602. Installation and service must be performed by authorized personnel only. For additional information and

specications, see the MPS602 product page at www.extron.com.

Step 1 — Disconnect Power and Mount the MPS602

Disconnect power to the MPS602 and turn off all devices that will be connected to it. The MPS602 is housed in a full rack width,

8.5 inch deep, 1U high metal enclosure that can sit on a table with the provided rubber feet or can be rack mounted. Select a

suitable mounting location, choose an appropriate mounting option, and follow the instructions provided with the mounting kit.

Step 2 — Cable the Switcher

SIG LINK

DTP IN

SIG LINK

DTP OUT

50/60 Hz

100-240V 1.0A MAX

RGB OUT

HDMI

MIC

MIX

RS-232

MPS 602 SA

Tx Rx G

MUTE HDMI AUDIO

PHANTOM POWER

SELECT

OUTPUTS

AMP OUT REMOTE

OVER DTP

RS-232 IR

Rx GTx Tx Rx

RS-232 IR

Rx GTx Tx Rx

CLASS 2 WIRING

8Ω / 4Ω

INPUTS

AUDIO IN

AUDIO OUT

L 1 R L 2 R L 3 R

L VARIABLE R

L FIXED R

L 4 R L 5 R MIC LINE

op s

hij

elmr

Figure 1. MPS602SA Rear Panel

AC power — Connect to standard AC power: 100-240 VAC, at 50-60 Hz

Video

RGB/VGA video input group — Two female 15-pin HD connectors for VGA input (numbered 1 and 2 on the rear panel). The

connectors accept VGA signals.

NOTE: The MPS602 does not scale or convert video, however it does convert an analog RGB/VGA input to digital

for digital output. The output signal resolution is the same as the input resolution.

RGB video output — One 15-pin HD connector acting as a pass-through to output the selected RGB/VGA input.

HDMI video input group — Three HDMI connectors for HDMI compliant audio and video input (numbered 3, 4, and 5 on the

rear panel). Connect to any HDMI source device using standard HDMI cable.

HDMI video output — Connect an HDMI display device for output from the selected HDMI input (

DTP

DTP In — Connect a DTP 230 source (Tx) to this RJ-45 jack (numbered 6 on the rear panel). The DTP input includes the

HDMI (or DVI) video with embedded audio, bi-directional RS-232 and IR, separate balanced/unbalanced analog audio,

and remote power for a connected DTP Tx device (see Twisted Pair Recommendations for DTP Communication on

page4).

RS-232 and IR (Over DTP) In — One 3.5mm 5-pole captive screw connector provides connection for bi-directional RS-232

and remote IR signals between the DTPTx connected to input 6 (

) of the MPS602.

RS-232 and IR (Over DTP) Out — One 3.5mm 5-pole captive screw connector to connect and pass bi-directional RS-232

and IR between the MPS602 and DTP230 Rx.

RS-232 and IR Over DTP Wiring

To pass bidirectional serial command signals between DTP-compatible devices, connect a control device to the three

leftmost poles (Tx, Rx, and G) of the 5-pole captive screw connector.

NOTE: RS-232 and IR data can be transmitted or received simultaneously.

DTP output — Connect an Extron DTP 230 receiver (Rx) using this RJ-45 jack. The DTP 230 signal format and protocol is

used. The output can include HDMI (with embedded audio), bi-directional RS-232 and IR, separate analog audio (from the

xed audio output), and remote power for a connected DTP230 receiver.

DTP out or HDMI out selection switch — One single-pole double-throw switch to select which output, DTP (

) or HDMI

(

) is active.

1 2 3 4

Shrnutí obsahu

Strany 1 - MPS602 Series • Setup Guide

1IMPORTANT:Go to www.extron.com for the complete user guide, installation instructions, and specifications before connecting the product to the power

Strany 2 - Program Audio Output

2MPS602 • Setup Guide (Continued)Analog Audio Inputk Audio input group —Five 3.5mm, 5-pole captive screw connectors provide analog audio input to

Strany 3 - MPS SERIES

31 2 1 2 3 4 5 6MPS SERIESMEDIA PRESENTATION SWITCHERMUTEMUTEMICPROGRAM AUDIOINPUTSRGBCONFIGEXECMODEab dce ghijklfFigure 3. MPS602SA Front PanelSt

Strany 4 - Pair Wires

4SFSFSFSFSFSFSFSFSFSFSFSFSFSFFront Panel LEDsVGA Input 1VGA Input 2Input 1Input 2Input 3Input 4Input 5Input 6Exec Mode876543219= on

Komentáře k této Příručce

Žádné komentáře

Extron-electronics MPS 602 Series Setup Guide Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Příslušenství pro video Extron-electronics MPS 602 Series Setup Guide. Extron Electronics MPS 602 Series Setup Guide User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Příslušenství pro video Extron-electronics MPS 602 Series Setup Guide